8′

 

This plan for a louvered deck roof can be altered to fit your needed size. Just adjust quantities accordingly. And don’t forget to look at Howie’s Tips at the bottom of the page… he always offers great insights. Good Luck!

Dimensions

FLEX•fence 2 post deck roof – 10′ X 8′ X 8′

Note

The drawings are to be used as a guide only.

MATERIAL LISTING

 

  • 4 FLEX•fence 4′ Kit
  • 2 FLEX•POST BRACKET ( 4″ x 4″ Post Bottoms)
  • 2 FLEX•ROOF BRACKET ( 4″ x 4″ Post Tops)
  • 2 FLEX•ANGLE BRACE (For Deck Roofs)
  • 2/pcs. – 2″ x 6″ x 120″
  • 44/pcs. – 1″ x 6″ x 56 1/2″
  • 4/pcs. – 2” x 4” x 120”
  • 6/pcs. – 2” x 4” x 48 ¾”
  • 2/pcs. – 2” x 4” x 15 ½”
  • 2/pcs. – 5/4″ x 6″ x 120″
  • 2/pcs. – 4″ x 4″ x 108″
  • 1 sheet of exterior plywood
  • 8/pcs – 5/16th x 6″ carriage bolts with appropriate nuts and washers
  • #8 – 2″ wood screws
  • Wood plugs (optional)
  • 4/pcs. – 3/16th x 1 ¾” machine eyebolts with appropriate nuts, washers and t-nuts
  • Carpenter’s glue
  • Sandpaper
  • Decorating: stain or paint

TOOLS REQUIRED

 

  • Pencil
  • Measuring Tape
  • #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
  • #2 Robertson Screw Drive-Red Handle (Philips Screw Driver)
  • Hand Saw
  • Hammer
  • Chisel
  • Combination Square
  • Protective Eyewear
  • Level

OPTIONAL TOOLS

 

  • Drill with appropriate bits & counter sink bit
  • Router with decorative bits
  • Power saws – Mitre & Skill

HOWIE’S TIPS

  1. Once your Roof is constructed, create drainage (drill holes) in wood marked ‘A’ in Roof Plans and on bottom of the Planters.
  2. When attaching the FLEXfence brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
  3. When sizing FLEXfence always cut the rails and operating bar with hand tools and never with power tools.
  4. Always wear protective goggles.

PRINTABLE PDF FILE