Cut list - Flexfence full size louvered gate

Click here to download PDF format (85 Kb)

Material Listing

• 1 /kit FLEX•fence ®
• cut track into 2 sections measuring 22" each. (leave 3 " from 1st pre-punched hole)
• 2/pcs. - 4" x 4" x 4’
• 10/pcs. - 1" x 6" x 31¾"
• 6/pcs. –1" x 6" x 24 ¾"
• 2/pcs.-1" x 4" x 36"
• 2/pcs. – 2" x 4" x 33"
• 2/pcs. – 2" x 4" x 69"
• 1" finishing nails
• Exterior grade carpenter's glue

Tools Required

• Pencil
• Measuring Tape
• #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
• #2 Robertson Screw Drive-Red Handle (Philips -Screw Driver)
• Hand Saw
• Hammer
• Chissel
• Combination Square
• Protective Eyewear
• Level

Optional Tools

• Drill with appropriate bits & counter sink bit
• Router with decorative bits
• Power saws - Mitre & Skill

Howie's Tips

1. When attaching the FLEX•fence ® brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
2. When sizing FLEX•fence ® always cut the rails and operating bar with hand tools and never with power tools.
3. Always wear protective goggles.

Note: The drawings are to be used as a guide only.

Back to Do-it-yourself Projects home

Back to top