Dimensions - Flexfence fully louvered deck railing

Click here to download PDF format (94 Kb)

Material Listing

• 2/kits FLEX•fence
• 4/pcs.- 2"x4"x37 ¾"
• 2/pcs. - 2"x4"x 72"
• 9/pcs. – 1"x6"x 20 ½"
• 10/pcs. – 1"x6"x36 ¾"
• 1" finishing nails
• 4/pcs. - wood plugs (optional)
• Exterior grade carpenter's glue

Tools Required

• Pencil
• Measuring Tape
• #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
• #2 Robertson Screw Drive-Red Handle (Philips -Screw Driver)
• Hand Saw
• Hammer
• Chissel
• Combination Square
• Protective Eyewear
• Level

Optional Tools

• Drill with appropriate bits & counter sink bit
• Router with decorative bits
• Power saws - Mitre & Skill

Howie's Tips

1. Cut one kit of FLEX•fence ® rails into 2 sections each measuring 22" (Make the first cut 3" from 1st pre-punched hole).
2. When sizing FLEX•fence ® always cut the rails and operating bar with hand tools and never with power tools.
3. When attaching the FLEX•fence ® brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
4. Always wear protective goggles.

Note: The drawings are to be used as a guide only.

Back to Do-it-yourself Projects home

Back to top