Dimensions - Flexfence louvered patio door awning

Click here to download PDF format (93 Kb)

Material Listing

• 2/kits FLEX•fence
• 2/pcs.- 2" x 4" x 80" OR - 2" x 3" x 80"
• 3/pcs.- 2" x 4" x 36" OR - 2" x 3" x 36"
• 16/pcs.-1" x 6" x 341/4"
• 2/ FLEX·Awning Brackets (could substitute with your own wood brackets)
• 4/pcs.- 5/16th x 4" carriage bolts with appropriate nuts and washers
• 4/pcs- ¼" x 3" expansion anchors (depending on wall construction)
• 12/pcs. - #8- 2" wood screws
• 12/pcs. - wood plugs (optional)
• 4/pcs. - 3/16th x 1 ¾" machine eyebolts with appropriate nuts,
• washers and t-nuts
• carpenter's glue
• sandpaper
  +
• Decorating: stain or paint.

Tools Required

• Pencil
• Measuring Tape
• #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
• #2 Robertson Screw Drive-Red Handle (Philips -Screw Driver)
• Hand Saw
• Drill with appropriate bits & counter sink bit
• Hammer
• Chissel
• Combination Square
• Protective Eyewear
• Level

Optional Tools

• Router with decorative bits
• Power saws - Mitre & skill or table saw

Howie's Tips

1. When attaching the FLEX•fence ® brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
2. When sizing FLEX•fence ® always cut the rails and operating bar with hand tools and never with power tools.
3. Always wear protective goggles.

Note: The drawings are to be used as a guide only.

Back to Do-it-yourself Projects home

Back to top