Do-it-yourself Projects
Project 11 - Board on Board Fence with Louver Top - 4 ft. Section
Click here to download PDF format (70 Kb)
Material Listing
- 1/kit FLEX•fence ® Cut the kit to 42" (leave 3" space from pre-punched holes on each end)
- 2/pcs.- 4" x 4" x 84"
- 9/pcs.- 1" x 6" x 21 ¼"
- 10/pcs.- 1" x 6" x 45"
- 5/pcs.- 2" x 4" x 46 ¼"
- 1/pcs.- 2" x 6" x 68 ¼"
- 2/pcs.- 1" x 4" x 64 "
- 2" Spiral nails
- Exterior grade carpenter's glue
Tools Required
- Pencil
- Measuring Tape
- #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
- #2 Robertson Screw Drive-Red Handle (Philips -Screw Driver)
- Hand Saw
- Hammer
- Chissel
- Combination Square
- Protective Eyewear
- Level
Optional Tools
- Drill with appropriate bits & counter sink bit
- Router with decorative bits
- Power saws - Mitre & Skill
Howie's Tips
- When attaching the FLEX•fence ® brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
- When sizing FLEX•fence ® always cut the rails and operating bar with hand tools and never with power tools.
- Always wear protective goggles.
Note: The drawings are to be used as a guide only.
|
