Do-it-yourself Projects
Project 1 - Louvered Screen for Indoors and Out
 |
 |
| Dimensions - Flexfence 2 panel louvered screen (each panel measures 78"x26") |
Click here to download PDF format (82 Kb)
Material Listing
- 3/kits FLEX•fence (each panel requires 1 1/3 kits)
- 4/pcs.- 2'x4'x10' pine (cedar could be used for exterior use)
- 30/pcs. - 1"x6"x 24" (MDF board can be used inside)
- 8/pcs. - 5" wood ornamental brackets
- 3/pcs. - hinges (your choice e. g. brass)
- 16/pcs. - #8-2" wood screws
- 1" finishing nails
- 16/pcs. - wood plugs (optional)
- Carpenter's glue
Tools Required
- Pencil
- Measuring Tape
- #1 Robertson Screw Driver-Green Handle or (Philips Screw Driver)
- #2 Robertson Screw Drive-Red Handle (Philips -Screw Driver)
- Hand Saw
- Hammer
- Chissel
- Combination Square
- Protective Eyewear
- Level
Optional Tools
- Drill with appropriate bits & counter sink bit
- Router with decorative bits
- Power saws - Mitre & Skill
Howie's Tips
- When attaching the FLEX•fence ® brackets onto the rails allow for the brackets to move freely (swivel). Do not over tighten!
- When sizing FLEX•fence ® always cut the rails and operating bar with hand tools and never with power tools.
- Always wear protective goggles.
Note: The drawings are to be used as a guide only.
|
